When the physical device driver is enabled for this mode of operation and DSR is OFF, the physical device driver discards receive data.

Initial Value

Input Sensitivity using DSR is enabled
First Level Open
No effect
Mode Utility
User interface to enable/disable this mode of the physical device driver
Automatic Override
When Input Sensitivity Using DSR is enabled, the physical device driver responds to the lowering of the DSR line within a single character time. That is, the Extended Hardware Buffering (Receive Trigger Level) is adjusted so the device generates an interrupt for each character received. The full 16-character receive buffer is still available to help avoid any receive hardware overruns. The Transmit FIFO feature is also still enabled so that only one transmit interrupt occurs for every 16 characters transmitted.

Note: In situations where DSR can naturally drop from O to OFF at the end of a communications session, but is not normally toggled during the session, it is most advantageous to disable Input Sensitivity Using DSR after the communications data transfer has begun. This achieves a significant performance benefit (under the control of Automatic Protocol Override), without the risk of losing valid data upon termination of the session. If, however, the DSR signal is expected to toggle frequently during a communications session, Input Sensitivity Using DSR should not be disabled, or potential data loss can result.

---

[Back] [Next]